Guangdong Shunde Hantec Building Materials Co. , Ltd. was established in 2007
 |
Product Introduction
The Hantec-340B is a universal, medium viscosity, high strength adhesive. It is suitable for transition, interference or clearance fit. Hold the key and shaft, bearing, small motor rotor shaft, bushing, improve the fit strength of pressure fit, repair worn hole - shaft fit or out of tolerance parts, screw lock seal.
Typical use for bearing and sliding fitting assembly fixed. It is used for fixing cylindrical parts with maximum radial clearance of 0.10mm. Typical applications: general purpose, holding key and shaft, bearing, small motor rotor shaft, bushing, sealing of threaded parts and filling of sand holes.
Main technical parameters
Usage
a) Grease should be removed and cleaned at the glue-coated parts. Metal cleaner is recommended; b) Uniformly apply the glue solution to the joint part of the workpiece and assemble it according to the conventional method; c)Set at room temperature for 24 hours; d)If stored for a long time, shake well when used.
matters need attention
A) Do not pour the poured gel solution back into the original bottle to avoid contaminating the gel solution. B) This product contains acrylic acid and hydroxypropyl methacrylate, which can irritate the skin and eyes. C) In case of accidental contact with eyes and skin when using this product, rinse immediately with clean water. D) This product should not be used on plastics.
Storage
a) Store in a cool and dry place at 8 ~ 28℃. b) Shelf life: two years
Packing specification
50g/piece；250 g/piece
*Note: The performance data above are typical data measured in a laboratory environment with temperature of 25℃ and humidity of 70%. They are only for reference and cannot be guaranteed to be achieved in a specific environment. Please refer to the actual test data when using.
Product Introduction
The Hantec-340B is a universal, medium viscosity, high strength adhesive. It is suitable for transition, interference or clearance fit. Hold the key and shaft, bearing, small motor rotor shaft, bushing, improve the fit strength of pressure fit, repair worn hole - shaft fit or out of tolerance parts, screw lock seal.
Typical use for bearing and sliding fitting assembly fixed. It is used for fixing cylindrical parts with maximum radial clearance of 0.10mm. Typical applications: general purpose, holding key and shaft, bearing, small motor rotor shaft, bushing, sealing of threaded parts and filling of sand holes.
Main technical parameters
Usage
a) Grease should be removed and cleaned at the glue-coated parts. Metal cleaner is recommended; b) Uniformly apply the glue solution to the joint part of the workpiece and assemble it according to the conventional method; c)Set at room temperature for 24 hours; d)If stored for a long time, shake well when used.
matters need attention
A) Do not pour the poured gel solution back into the original bottle to avoid contaminating the gel solution. B) This product contains acrylic acid and hydroxypropyl methacrylate, which can irritate the skin and eyes. C) In case of accidental contact with eyes and skin when using this product, rinse immediately with clean water. D) This product should not be used on plastics.
Storage
a) Store in a cool and dry place at 8 ~ 28℃. b) Shelf life: two years
Packing specification
50g/piece；250 g/piece
*Note: The performance data above are typical data measured in a laboratory environment with temperature of 25℃ and humidity of 70%. They are only for reference and cannot be guaranteed to be achieved in a specific environment. Please refer to the actual test data when using.
